[PATCH v5 03/14] kbuild: rename the strip_relocs command

[Thomas Weißschuh]

This command is doing more than just stripping relocations.
With the introduction of CONFIG_MODULE_HASHES it will do even more.

Use a more generic name for the variable.

Signed-off-by: Thomas Weißschuh <linux at weissschuh.net>
---
 scripts/Makefile.vmlinux | 8 ++++----
 1 file changed, 4 insertions(+), 4 deletions(-)

diff --git a/scripts/Makefile.vmlinux b/scripts/Makefile.vmlinux
index fcae1e432d9a..6cc661e5292b 100644
--- a/scripts/Makefile.vmlinux
+++ b/scripts/Makefile.vmlinux
@@ -91,13 +91,13 @@ remove-symbols := -w --strip-unneeded-symbol='__mod_device_table__*'
 
 # To avoid warnings: "empty loadable segment detected at ..." from GNU objcopy,
 # it is necessary to remove the PT_LOAD flag from the segment.
-quiet_cmd_strip_relocs = OBJCOPY $@
-      cmd_strip_relocs = $(OBJCOPY) $(patsubst %,--set-section-flags %=noload,$(remove-section-y)) $< $@; \
-                         $(OBJCOPY) $(addprefix --remove-section=,$(remove-section-y)) $(remove-symbols) $@
+quiet_cmd_objcopy_vmlinux = OBJCOPY $@
+      cmd_objcopy_vmlinux = $(OBJCOPY) $(patsubst %,--set-section-flags %=noload,$(remove-section-y)) $< $@; \
+                            $(OBJCOPY) $(addprefix --remove-section=,$(remove-section-y)) $(remove-symbols) $@
 
 targets += vmlinux
 vmlinux: vmlinux.unstripped FORCE
-	$(call if_changed,strip_relocs)
+	$(call if_changed,objcopy_vmlinux)
 
 # modules.builtin.modinfo
 # ---------------------------------------------------------------------------

-- 
2.54.0